3. Engine replacement
D
C
Image 3-60
Integrating rod: shift
screen
Image 3-61
Integrating rod: rotated and in focus
Note:
Handle D is pushed to one direction by a spring but can be blocked at a certain position by nut C.
7. Push down screw A on the integrating rod until no more black borders are visible in the image
Image 3-62
Integrating rod: rotate
Image 3-63
Integrating rod: well aligned (rotation)
8. Tighten both screws A and B on the integrating rod. See image 3-57
9. Install the following parts (see concerning chapters):
-
engine fan cover 1
-
top cover
-
rear cover
3.4.3
Cold mirror alignment
Introduction
The position of the cold mirror can be adjusted by turning three screws. The cold mirror is aligned in the factory, which means that
no adjustment should be needed unless the cold mirror has been replaced or reinstalled.
A bad alignment of the cold mirror will result in lower light output and non uniformity of the brightness.
R59770591 ENGINE KIT 26/08/2010
31
