Barco FLM HD18, User Manual

Page: 47 / 193

6. Getting started
Ind. Key name Description
13 Picture controls Use these buttons to obtain the desired picture level.
14 PHASE Used to remove the horizontal instability of the image (usually for RGB source). It
adjusts the phase of the pixel sampling clock relative to the incoming signal.
15 FREEZ To freeze the actual projected image.
16 TEXT Toggle key to activate or deactivate on screen text boxes while adjusting a setting.
When adjusting one of the image controls, e.g.during a meeting, the normally displayed
bar scale can be deactivated by pressing ’TEXT’ key first. To re-display the bar scale
on the screen, press ’TEXT’ key again. When TEXT is ’off’, no adjustment menu’s
will be displayed on the screen when entering the adjustment mode. All menus and
adjustments remain active on the local LCD panel.
17 ENTER Key to confirm an adjustment or selection in the adjustment mode.
18 Cursor keys To make menu selections when in the adjustment mode
19 EXIT Key to go one menu stage higher than the actual position when in the adjustment mode.
20 WINDOW Selection of the active window, also in PIP mode.
21 PIP Direct access key for picture in picture selection.
22 RC Operating indication Lights up when a button on the remote control is pressed. (This is a visual indicator to
check the operation of the remote control)
Table 6-1
6.3 Operating the projector
Overview
• Switching on
• Errors, warnings and messages during start up
• Switching to standby
• Switching off
6.3.1 Switching on
How to switch on.
1. Press the power switch to switch on the projector.
Image 6-2
Switching on
- When ’0’ is visible, the projector is switched off.
- When ’1’ is visible, the projector is switched on.
The projector starts up in standby. The menus are accessible via the local LCD panel.
To display an image, the standby key must be pressed once.
R5976986 FLM HD18 01/09/2006 43