R5906852-01
F80 series
38
4.
Sleep 5 seconds.
5.
Send power on command (to switch in ON mode).
4.4 Status overview
Description
Once the projector is started, press
Status
to get an overview of parameters such as :
•
Chosen source
•
Current resolution and refresh rate
•
Device serial number and article number
•
Current firmware version and model name
•
Current illumination (in percentage)
•
Lamp runtime in hours
•
Chosen communication method and IP address (if connected)
•
Warp status
•
Environmental temperature
Image 4-2
4.5 Power off projector
How to Switch off the projector
1.
Use the
standby button
, or the
Power On
button on the remote control, to switch off the projector.
The projector will switch to
READY
mode first in order to run through a cool down phase (see
”
2.
If
ECO
Standby mode is enabled in the service menu (refer to the section "GUI - system settings/Standby
ECO", in User Guide) the projector will automatically go to
ECO
standby mode after a time-out (default 15
minutes).
Some actions like apply a grey test pattern are done during the two minutes of the cool down phase
in order to minimize the potential effect of burn-in and increase the projector lifetime.
CAUTION:
Never switch off the projector by means of unplugging mains cord or by cut down of
mains power.
Summary of Contents for F80 series
