![background image](http://html1.mh-extra.com/html/barco/coronis-5mp-mammo/coronis-5mp-mammo_system-manual_3886855018.webp)
System manual Coronis 5MP
19
1. Turn off the power to your computer and disconnect the power
cord.
2. Remove the chassis cover according to the manufacturer’s
instructions. Be sure to observe safety warnings.
3. If you have decided to use the on-board VGA capabilities of the
5MP2F (see Using the VGA capabilities of the BarcoMed 5MP2F),
you must now remove
must now remove
must now remove
must now remove
must now remove any VGA display controller(s) that are
currently installed in the computer.
4. Install the 5MP2F Graphics Controller into a free PCI slot, either 32
bit or 64 bit (see figure 2, for examples of slots). Be sure that the
display controller is seated firmly in the slot.
5. Secure the card to the chassis with the PC’s I/O panel mounting
screw, and replace the chassis cover.
6. Connect the primary display (left most display in a linear
configuration, top most in a vertical configuration) to the uppermost
connector on the 5MP2F (the output farthest from the motherboard
– “VID 1
VID 1
VID 1
VID 1
VID 1” in figure 4 ) using the provided DVI cable. For a dual-
headed 5MP2F setup, connect the secondary display to the other
connector on the display controller.
7. Reconnect the power cord, turn on the power, and boot the system
as usual.
Figure 4: The Video Outputs.
Imaging board installation
Summary of Contents for Coronis 5MP Mammo
