System manual Coronis 5MP
105
3. Select the “Adapter”
“Adapter”
“Adapter”
“Adapter”
“Adapter” tab and then click on the “List
“List
“List
“List
“List All Modes…”
All Modes…”
All Modes…”
All Modes…”
All Modes…”
button. Select the resolution and refresh rate that your CORONIS
display supports from the dialog box and click “OK”
“OK”
“OK”
“OK”
“OK”.
Note:
Note:
Note:
Note:
Note: The resolutions shown will be based on the number of
heads the display controller supports.
For example: The BarcoMed 5MP2F Display Controller
supports two CORONIS display panels. If the resolution of
each display is 2048x2560x256, Windows XP will display the
resolution as 4096x2560x256. If necessary you can change
the number of display panels later by using the BarcoMed
Driver Tab.
4. Click “OK”
“OK”
“OK”
“OK”
“OK” on the bottom of the Adapter Control Panel. If the
“OK”
“OK”
“OK”
“OK”
“OK” button on the bottom of the Adapter Control Panel is not
visible, press the “T
“T
“T
“T
“Tab Key”
ab Key”
ab Key”
ab Key”
ab Key” once and then press “Enter”
“Enter”
“Enter”
“Enter”
“Enter”. Your
CORONIS display(s) should now synchronize and display the
Windows desktop.
5. Click “Y
“Y
“Y
“Y
“Yes”
es”
es”
es”
es” if asked, “Your desktop has been reconfigured. Do
you want to keep these settings?”
Repeat steps 1 – 5 to set the resolution of the displays attached to
each BarcoMed Display Controller installed in your system.
Figure 88: Windows XP Display Properties Settings Tab for the 5MP2F with
DualView disabled.
Note:
Note:
Note:
Note:
Note: The system shown in figure 88 above is a dual-head, single
BarcoMed 5MP2F display controller, no 3
rd
party VGA card
configuration. Your system may look different.
BarcoMed software driver installation
Summary of Contents for Coronis 5MP Mammo
