Barco ClickShare CSE-800, Installation Manuals

Page: 77 / 118

R5900049 /07 ClickShare CSE-800 77
Image 6-23: LAN settings
3. Click in the input field next to Hostname and enter a host name for the Base Unit.
The default host name is ClickShare-<serial number Base Unit> .
4. Click Save changes to apply the settings.
Setup the primary and secondary interface
1. To select the method, click on the drop down box next to Method and select the Automatic (DHCP) or Manual .
When Automatic (DHCP) is selected, the IP address, subnet mask and default gateway fields are grayed out
but the currently used settings are filled out.
For manual setup, see “ Manual (fixed) IP address ” .
Manual (fixed) IP address
1. Click on the drop down box next to Method and select Manual .
The IP address, subnet and gateway input fields are activated.
The default IP addresses are filled out.
For the primary interface: “ 192.168.0.23 ” . For the secondary interface: “ 192.168.1.23 ” . Both with subnet mask
“ 255.255.255.0 ” .
2. Click in the input field of the IP address and fill out the 4 octets.
Note: An address contains 4 octets with a maximum value of 255.
This must NOT be 0.0.0.0 for static IP-Address assignment
3. Click in the Subnet mask input fields and fill out the 4 octets as appropriate for the local subnet.
4. Click in the Default Gateway input fields and fill out the 4 octets. Set the Default-Gateway to the IP-Address of
the router (MUST be on the local subnet!).
Note: This must NOT be 0.0.0.0.
If there is no router on the local subnet then just set this field to any IP-Address on the subnet.
CSE-800 Configurator