Installation Adjustments
R5975819.05 BARCO CINE 6 21112002 ____________________________________________________________________________ 7-7
Loosen the two hexagon screws A and A' upper and lower fixation latch. These screws fasten the cooling house of the red
tube. Pivot the red CRT until the center of the red image coincides with the center of the green image. If the tube is hard to
pivot, loosen also screw B a little bit. If the angle of the red CRT is corrected, tighten the bolts again.
ENTER
continues to blue and green crosshairs.
EXIT
will return to CRT projection angle adjustment.
Loosen the two hexagon screws D and D' upper and lower fixation latch. These screws fasten the cooling house of the blue
tube.
Screws A, B, C and D (M4) : upper
fixation latch. nutdriver 7mm.
Screw A', B', C' and D' (M4) : lower
fixation latch. nutdriver 7mm.
red crosshair
green crosshair
red crosshair
green crosshair
Move the red CRT
to the outside,
away from the
green CRT
Move the red CRT to-
wards the green CRT
Pivot the blue CRT until the center of the blue image coincides with the center of the green image. If the tube is hard to pivot,
loosen also screw C a little bit. If the angle of the blue CRT is corrected, tighten the bolts again.
ENTER
continues to the path selection menu.
EXIT
returns to the CRT projection angle adjustment.
After finishing the installation adjustments procedure, the
'Path selection'
returns on the screen. You are now able to start the
blue crosshair
green crosshair
blue crosshair
green crosshair
Move the blue CRT
to the outside,
away from the
green CRT.
Move the blue CRT
towards the green
CRT.
A
B
D
C
CRT PROJECTION ANGLE
ADJUSTMENT
Align cross hairs
<ENTER> to continue
<EXIT> to return.
CRT PROJECTION ANGLE
ADJUSTMENT
Align crosshairs
<ENTER> continue
<EXIT> to return.
