Installation Set Up
4-2 ____________________________________________________________________________ R5975819.05 BARCO CINE 6 21112002
Scan adaptation
The scanning can be switched by turning the Horizontal and Vertical scan connectors.
To change the scanning, it is necessary to open the projector top cover (see "Access to control").
To gain access to the connectors, the top frame has to be turned 90° to the back until it grips into its locks.
Therefore, the following the next procedure :
•
Remove the four screws, two on each side, that are fixing the heatsinks to the frame (image 1).
•
Remove three screws that are fixing the frame to the metal chassis.
•
Pivot the frame 90° to the back. It is possible that you have to pull strongly on the frame to open it.
WARNING :
TURN OFF PROJECTOR AND UNPLUG THE POWER CORD BEFORE CHANGING THE SCAN DIRECTION.
Scan Inversion
A : Horizontal scan inversion
Three connectors are used, one for each horizontal deflection coil. When changing the horizontal scan, ensure that all three
connectors are set in the same position. See position of the connectors for the corresponding projector configuration.
B : Vertical scan inversion
Three connectors are used, one for each vertical deflection coil. When changing the vertical scan, ensure that all three connectors
are set in the same position. See position of the connectors for the corresponding projector configuration.
r /
Ceiling
Front
/
Table
Front
/
Ceiling
Rear
/
Table
Rea
Horizontal
scan
inversion
Vertical
scan
inversion
B
R
B
R
B
R
B
R
B
R
B
R
R
B
R
B
R
B
Y
G
Y
G
Y
G
Y
G
Y
G
Y
G
R
B
R
B
R
B
G
Y
G
Y
G
Y
G
Y
G
Y
G
Y
Color of the wires is as follows :
R = Red, B = Blue, Y = Yellow, G = Green
Remarks : As per the factory setting, this photo is in Front / Ceilling position.