Power Connection
R5975819.05 BARCO CINE 6 21112002 ____________________________________________________________________________ 6-1
POWER CONNECTION
Power (mains) cord connection
Use the supplied power cord to connect your projector to the wall outlet. Plug the female power connector into the male connector
at the front of the projector.
Input power (mains) voltage adaptation
Attention
The
BARCO CINE 6 - R9002372
leaves the factory with a PFC module to operate on a mains (power) input from 110Vac to 230Vac.
6
Stand By / Operational
Pause
Sync
Hold Down EHT
IR
120 / 230 V
4 A / 2.5 A
60 / 50 Hz
300 W
Fuses
Warning :
For continued protection against fire hazard :
- replace with the same type of fuse
- refer replacement to qualified service personnel
Fuse type : 2 x T5A/250V (Barco order number : R314104)
Switching on/off
The projector is switched ON and OFF using the power (mains) switch ON/OFF.
Pressed
: ON
Not pressed : OFF
The projector can start now in the 'operational mode' (image displayed) or in the 'stand by mode' (see projector set up)
Stand by indication lamp :
Green : projector in operational mode
Red
: projector is in stand by.