Barbecook BC-GAS-2036, Manual

Page: 27 / 313

hot.
- The hose must be replaced if it becomes damaged or
shows signs of tearing, if national regulations stipulate this
or in accordance with their applicability.
• The gas bottle must always be upright.
• Check for gas leaks whenever you make modifications to
gas connections. See "7.5. Checking for gas leaks".
6.3. Connect the hose to the appliance
France:
The appliance can be used with 2 types of gas hose.
• Gas hose to be attached to the hose tails on the appliance
and on the pressure regulator, secured with hose clamps (in
accordance with XP D 36-110).
Recommended length 1.25 m
• Gas hose (in accordance with XP D 36-112) equipped with
a nut G ½ for direct connection to the appliance and a nut
M20 x 1.5 m for direct connection to the pressure regulator,
recommended length 1.25 m.
Other countries:
A flexible hose suitable for butane or propane gas is
recommended. The hose must not be longer than 1.50 m.
To be able to connect the gas hose to the appliance, fit a
coupling to the gas tube on the appliance. The appliance
is supplied with two different couplings intended for use in
different countries.
Country Coupling
BE, CH, CZ, DK, ES,
FI, GB, IE, IT, PT, SI
Coupling A
FR Coupling B
If your country is not listed in the table, use the coupling
that meets the standards that apply in your country.
6.3.1. Coupling A
You require a 19 mm wrench and a Phillips screwdriver.
1. Screw the coupling onto the gas tube on the appliance (A)
and tighten it with a 19 mm wrench (B).
A
B
2. Slide the hose over the coupling (C) and tighten the
clamping ring with a Phillips screwdriver (D).
TIP: Apply a small amount of dish soap to the coupling
and heat the end of the gas hose with a hair drier so that it
slides smoothly over the coupling.
C D
6.3.2 Coupling B
You require a 22 mm wrench and an adjustable wrench.
1. Screw the coupling onto the gas tube on the appliance (A)
and tighten it with a 22 mm wrench (B).
A B
2. Screw the gas hose onto the coupling (C) and secure it
with two wrenches. Hold the coupling firm with one 22 mm
wrench and tighten the hose with an adjustable wrench.
C D
6.4. Connect the hose and gas bottle to the regulator.
You will require a Phillips screwdriver and/or an adjustable
wrench depending on the type of regulator that you are using.
1. Connect the hose to the pressure regulator. Proceed as
follows:
• If the hose is fitted with a clamping ring, slide the hose over
the regulator and tighten the clamping ring with a Phillip
screwdriver (A).
• If the hose is fitted with a nut, screw the hose onto the
regulator and tighten the nut with and adjustable wrench
(B).
2. Connect the pressure regulator to the gas bottle. Proceed as
follows:
• If the regulator is fitted with a nut, screw the regulator
onto the gas bottle clockwise and tighten the nut with an
adjustable wrench (C).
www.barbecook.com 27