Operation manual
Bär SmartControl 2.0
40000001186_EN_03.docx
Page 19 / 39
Date: 31/03/2020
5
Pairing system components
A SmartControl 2.0 system only ever supports 1 active pairing with a hand-held transmitter. Another hand-
held transmitter can be paired at any time.
The following functions are available for this purpose:
Initial hand-held transmitter pairing - Very first hand-held transmitter
Repeat hand-held transmitter pairing for every other hand-held transmitter
When a hand-held transmitter has been successfully paired, the pairing of the previous transmitter
is deleted. A hand-held transmitter can only be paired if it has not been paired with another system
beforehand. In this case it must be reset before being paired again, unless pairing takes place
using EasyPairing.
5.1 Initial hand-held transmitter pairing
Before the Bär SmartControl 2.0 system is ready for use, the hand-held transmitter must be paired with the
Cargolift. If no hand-held transmitter has been p
aired to the Cargolift yet, the “Initial hand-held transmitter
pairing” function is available.
Entry
Display
Description
The following prerequisites apply for the initial pairing of a hand-
held transmitter to a system:
-
No hand-held transmitter has been paired with this
system so far.
-
A foot control electronic is connected to the eBC
Controller 2.0 of the system.
-
The hand-held transmitter has not been paired with
another system.
-
The hand-held transmitter is located in the reduced near
field.
The system is built into the truck:
Press “Truck” pushbutton 2 x.
After approx. 3 s the red LED under the truck symbol
blinks.
Pairing successful:
The green LED and red LED under the truck symbol
illuminate.
The system is built into the trailer:
Press “Trailer” pushbutton 2 x.
After approx. 3 s the red LED under the trailer symbol
blinks.
Pairing successful:
The green LED and red LED under the trailer symbol
illuminate.
If the pairing is successful, the hand-held transmitter is logged in to the system and the control voltage
of the Cargolift is switched on.
The configuration file specifies the button which can be paired with.
Truck entry = Truck pushbutton
Semitrailer or trailer entry = trailer pushbutton
rna
2x
2x
