Battery Level Indicator
VFO / MR - mode key
A / B select key
The status LED has a very simple and traditional design. When you receive a signal it
shows green, when you transmit it shows red, and it's off in standby.
Status LED
When the battery level indicator reads the battery is depleted. At this point the radio
will start beeping periodically as well as flashing the backlight of the display and when
voice prompts are enabled, a "Low Voltage" announcement will be heard, indicating that
you need to change your battery or put your radio in the charger.
Side key 1 - CALL (Broadcast FM and Alarm)
Press momentarily to start the broadcast FM receiver. Another momentary press turns
the broadcast FM receiver off. If a signal is received on the active frequency or channel
while you are listening to the broadcast FM, the squelch will be activated to that frequency
(as if scanning) and remain there until the signal goes away; it will then switch back to
broadcast FM.
Press and hold to activate the alarm function. Press (a short press) again to turn it
off.
Side key 2 - MONI (Monitor and Flashlight)
Press momentarily to turn on the LED flashlight. Another momentary press will flash
the LED. Another momentary press turns the flashlight off.
Press and hold to monitor the signal. This will open up the squelch so you can listen
to the unfiltered signal.
Pressing switches between Frequency (VFO) Mode and Memory (MR) mode.
Memory mode is sometimes also referred to as Channel mode.
To save frequencies to channel memory you must be in Frequency (VFO) mode.
VFO/MR
The key switches between A (upper) and B (lower) displays. The frequency or
channel on the selected display becomes the active listening and transmit frequency
or channel.
A/B
Visit Radioddity.com For Downloads And Help
14
Visit Radioddity.com For Downloads And Help
15
