63
Mutes the speaker of the transceiver in
the absence of a specific low-level digital
signal. If the station you are listening to
does not transmit this specific signal, you
will not hear anything.
Mutes the speaker of the transceiver
in the absence of a specific and
continuous sub-audible signal. If the
station you are listening to does not
transmit this specific and continuous
signal, you will not hear anything.
10
11
OFF[0] see CTCSS
Table in
Appendix C
12
T-DCS-
Transmitter DCS
OFF[0] see DCS Table in
Appendix C
Transceiver a specific low-level digital signal
to unlock the squelch of a distant receiver
(usually a repeater)
13
T–CTCS-
Transmitter
CTCSS
OFF[0] see CTCSS Table in
Appendix C
Transceiver a specific and continuous sub-
Audible signal to unlock the squelch of a
distant receiver(usually a repeater).
14
VOICE- Voice
Prompt
OFF[0]| ENG [1]|
CHI [2]
Allows audible voice confirmation of a key
press
15
ANI-ID-
Automatic
Number ID
Displays the ANI code that has set by
Software. This menu cannot be used to
change it. The ANI-ID is sent when the
alarm is activated and menu 32=CODE
R-DCS-Receiver
DCS
R-CTCS -
Receiver CTCSS
OFF[0] see DCS Table in
Appendix C
Determines when DTMF Side Tones can be
Heard from the transceiver speaker.
Selects 1 of 15 DTMF codes. The DTMF
codes are programmed with software and
are up to 5 digits each.
16
17
18
SC-REV-Scanner
Resume Method
Scanning Resume Method
19
When to Sand PTT-ID
Codes are sent during either the beginning
or ending of a transmission.
20
PTT-ID Delay (milliseconds)
DTMFST- DTMF-
Side Tone of
Transmit code
S-CODE Signal
Code
OFF [0]: No DTMF side
Tones are heard DT-ST
[2]: Side Tones are heard
Only from automatically
keyed DTMF codes
DT+ANI [3]: All DTMF Side
Tones Are heard
1[0] |2[1] |3[2] |4[3]
|5[4] |6[5] |7[6] |8[9]
|9[8] |10[9] |
11[10] |12[11] |13[12]
|14[13] |15[14]
PTT-ID – When
to send the
PTT-ID
PTT-LT-Signal
Code sending
delay
To [0]: Time Operation-scan
-
ning Will resume after a fixed
time has Passed CO [1]:
Carrier Operation-
Scanning will resume after
the signal disappears
SE [2]: Search Operation-
Scanning will not resume
OFF [0]: No ID is sent
BOT [1]: The selected S-CODE
is Sent at the beginning
EOT [2]: The selected S-CODE
is Sent at the beginning and
ending
0-50ms
Visit Radioddity.com For Downloads And Help
56
Visit Radioddity.com For Downloads And Help
57
