Banner T30RW, Instruction Manual

Page: 30 / 43

June 23, 2023
T30RW R-GAGE Washdown Radar Sensor Instruction Manual
30
Output Ratings
Analog Outputs:
· Current Output (T30R….-.I.. models): 1 kΩ maximum load
resistance at 24 V; maximum load resistance = [(Vcc - 4.5)/
0.02 Ω]
· Voltage Output (T30R….-.U.. models): 2.5 kΩ minimum load
resistance
Discrete Outputs:
· Current rating = 50 mA maximum each
Black wire specifications per configuration
IO-Link
Push/Pull
Output High ≥ Vsupply - 2.5 V
Output Low ≤ 2.5V
PNP
Output High ≥ Vsupply - 2.5 V
Output Low ≤ 1V (loads ≤ 1 MegΩ)
NPN
Output High ≥ Vsupply - 2.5 V
Continued on page 31
Continued from page 29
Black wire specifications per configuration
Output Low ≤ 2.5 V
White wire specifications per configuration
PNP
Output High ≥ Vsupply - 2.5 V
Output Low ≤ 2.5 V (loads ≤ 70 kΩ)
NPN
Output High ≥ Vsupply - 2.5 V
Output Low ≤ 2.5 V
Advanced Capabilities
Available only in dual discrete models
Certifications
E224071
UL Environmental Rating: Type
1
Banner Engineering BV Park
Lane, Culliganlaan 2F bus 3,
1831 Diegem, BELGIUM
Turck Banner LTD Blenheim
House, Blenheim Court,
Wickford, Essex SS11 8YT,
Great Britain
ETSI EN 305 550-1 V.1.2.1
ETSI EN 305 550-2 V.1.2.1
FCC ID: UE3-T30R
IC: ID 7044A-T30R
for others, contact Banner Engineering
Country of Origin: USA
Operation of the T30RW sensor on board an aircraft or a satellite shall be prohibited.
FCC Part 15 Class A
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
Industry Canada Statement for Intentional Radiators
This device contains licence-exempt transmitters(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
This device may not cause interference. 1.
This device must accept any interference, including interference that may cause undesired operation of the device.
2.
© Banner Engineering Corp.