Banner T30RW, Instruction Manual

Page: 15 / 43

June 23, 2023
T30RW R-GAGE Washdown Radar Sensor Instruction Manual
15
Advanced Target
Minimum Active Sensing Range : Sensor ignores anything from the face of the sensor to this defined range.
Maximum Active Sensing Range : Sensor ignores anything past this defined range.
Measurement Hold: A rate of change filter to smooth the output and reduce chatter. For more information,
see " Using Measurement Hold Example " on page 26 .
Hold Time: The period of time the sensor holds its last measurement and output status if the measurement changes
more than the Maximum Distance Increase or the Maximum Distance Decrease . Available when Measurement Hold is
set to enabled.
Maximum Distance Increase: The allowed limit the measurement can increase, or move farther away from the sensor,
before initiating the Measurement Hold . Setting this to zero disables it. Available when Measurement Hold is set to
enabled.
Maximum Distance Decrease: The allowed limit the measurement can decrease, or move closer to the sensor, before
initiating the Measurement Hold . Setting this to zero disables it. Available when Measurement Hold is set to enabled.
Sensor Polarity
Define the output and remote input signal type.
Sensor Lockout
Remote Input (Gray Wire) : Enable or disable the remote input wire.
Analog Tab
The following are the parameters on the Analog tab on the Sensor Settings pane. This tab is available for analog models.
Slope—Current-Sourcing Models
Positive
Slope
Near
Window
Far
Window
Analog Output (mA)
20
4
The analog current output tracks slightly beyond
Slope—Voltage-Sourcing Models, 0 V to 10
V
Positive
Slope
Near
Window
Far
Window
Analog Output (V DC)
10
0
The analog current output tracks slightly beyond the
upper window limit (up to 10.2 V)
Slope—Voltage-Sourcing Models, 0.5 V to
4.5 V
Positive
Slope
Near
Window
Far
Window
Analog Output (V DC)
4.5
0.5
The analog current output tracks slightly beyond
each window limit (0V - 5V)
Analog Span
Define the outer limits of the analog range. This can be used to create a positive or negative slope.
Analog output options:
Current: 4 mA to 20 mA
Voltage: 0 V to 10 V or 0.5 V to 4.5 V
Output
Loss–of–Signal : Sets the Analog Output value used by the sensor during a loss of signal. When a signal is restored,
measurement resumes.
Hold Last Value—The Analog Output holds the last value indefinitely during a loss of signal.
3.5 mA (0 V)—The Analog Output switches to this value 2 seconds after a loss of signal. For Voltage models, this is 0
V. (Default)
20.5 mA (10.5 V/5 V)—The Analog Output switches to this value 2 seconds after a loss of signal. For Voltage models,
this is 10.5 V.
Averaging: Use this menu to set the number of measurements that are averaged together for the analog output.
Increasing the averaging improves repeatability but increases the total response speed. The default is 1. The filter can be
set to 1, 2, 4, 8, 16, 32, 64, or 128. The total response time is show under Response Time.
© Banner Engineering Corp.