P/N 128185
Banner Engineering Corp.
•
Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
DX80 Quick Start Guide
5
GETTING STARTED – APPLY POWER
To apply power to the
Gateway
, connect 10-30V dc cable as shown.
To apply power to the
Node
, connect 10-30V dc cable or DX81 Battery Module as shown.
1 = BROWN
3 = BLUE
Brown
1
10-30V dc Input
Blue
3
Ground Input
1 = BROWN
3 = BLUE
Brown
1
10-30V dc Input
Blue
3
Ground Input
Apply power...
This reading occurs only at
initial application of power to the
Gateway.
The LCD display shows
the current I/O status of
the Gateway.
The Gateway starts in RUN mode.
Displays current Network ID (NID)
Device is ...
... Gateway (Device Address = 0)
Indicates the current status of the
I/O. The display will cycle through
each I/O point of the device, then
return to *RUN.
repeat
Apply power...
This reading occurs only at initial
application of power to the Node.
The LCD display shows
the current I/O status of
the Node.
The Node starts in RUN mode.
Displays current Network ID (NID)
Device is ...
... Node 1 (Node Address = 1)
Indicates the current status of the
I/O. The display will cycle through
each I/O point of the device, then
return to *RUN.
repeat
Quick Start:
STEP 3
> Apply Power, Node
Quick Start:
STEP 2
> Apply Power, Gateway
