8.
Press
UNIT ->INCH or UNIT->MM.
Press
or
to toggle between millimeters and inches.
The sensor is ready to accept the new
setting.
Select the distance measurement in millimeters or one- hundredth of one inch. The
displayed measurements have no decimals.
9.
Press
if the correct value is displayed. DIST mm <5392>
The
setting
is saved. The sensor returns to the Main menu.
Accessing the Factory Preset Menu
To access the FACTORY <PRESET> menu and to return to Run mode, follow the steps below:
1.
Press
to access the FACTORY <PRESET> menu: F-PRESET > OK.
All previous
settings
are deleted. The sensor returns to the following factory default
settings:
• Teach-In
◦
Limit value of measurement range
◦
Q1 and Q2 single-switching, normally open, Analog Mode 1
◦
Rising slope
•
Offset
– 0
• Unit – mm
• Serial – RS422
• Password – OFF
2. Press ESCAPE to leave the default
settings
intact. FACTORY <PRESET>.
The sensor returns to the Main menu without changing the default
settings.
3.
Press
to return to the factory default
settings.
F-PRESET OK! and FACTORY <PRESET>.
The sensor returns to the Main menu with factory default
settings
intact.
4. Press ESCAPE to return to Run mode: DIST in 4839.
The sensor returns to the Main menu with factory default
settings
intact.
Serial
Communications
Choose a
RS422-compatible,
SSI1/10-compatible,
or
SSI1/8-compatible
serial interface
connection
with Serial Select. Depending on the
setting
made in Serial Select, the
respective
interface parameters are displayed or changed. The following
settings
are possible:
Table 1:
RS422-Compatible
Serial Interface
Connection
Baud rate
4.8, 9.6, 19.2, 38.4 (factory default), or 57.6 KBaud
Data bit
8 or 7 (factory default)
Stop bit
1 (factory default) or 2
REPEAT mode (factory default)
The sensor
continuously
sends measured data via the serial interface without
waiting
for a request.
SINGLE mode
A string of measured data is supplied on request.
Parity
Even (factory default), but not shown on LCD menu.
Table 2:
SSI1/10-Compatible
Serial Interface
Connection
(factory default)
LSB
0.1 mm (10MIL)
Codes
BINARY24, BINARY24E, and BINARY25; GRAY24, GRAY24E, and GRAY25 (factory default)
Table 3:
SSI1/8-Compatible
Serial Interface
Connection
LSB
0.125 mm (8 MIL)
Codes
BINARY24, BINARY24E, and BINARY25; GRAY24, GRAY24E, and GRAY25 (factory default)
L-GAGE
®
LT7 Long-Range Time-of-Flight Laser Sensor
12
www.bannerengineering.com - Tel: +1-763-544-3164
P/N 120244 Rev. C
