Discrete Input Wiring for PNP Sensors
Discrete Input Wiring for NPN Sensors
DIx
PWR
10-30V dc
DIx
GND
dc common
Wiring Diagrams for Discrete Outputs
Connecting dc power to the communication pins will cause permanent damage. For the DX8x...C models, PWR in the wiring diagram refers to V+ on the wiring board and
GND in the wiring diagram refers to V- on the wiring board.
Discrete Output Wiring (PNP)
DOx
GND
PWR
10-30V dc
Load
dc common
Wiring Diagrams for Analog Inputs
Connecting dc power to the communication pins will cause permanent damage. Do not exceed analog input ratings for analog inputs. Only connect sensor outputs to
analog inputs.
Analog Input Wiring (10 to 30V dc Power)
Analog Input Wiring (4–20mA, 2-Wire, Externally
Powered Sensors)
Analog Input Wiring (4–20mA, 2-Wire, Switch Pow-
ered Sensors)
AIx
PWR
10-30V dc
GND
−
+
sensor
dc common
AIx
GND
dc common
external power
−
+
sensor
+
−
AIx
SPx
GND
−
+
sensor
dc common
(Only possible in models with switch power (SPx) out-
puts)
Wiring Diagrams for Analog Outputs
Connecting dc power to the communication pins will cause permanent damage. Do not exceed analog input ratings for analog inputs. Only connect sensor outputs to
analog inputs.
Analog Output Wiring
AOx
GND
dc common
PWR
10-30V dc
sensor
LED Behavior for the Gateways
After powering up and binding the Gateway and its Nodes, verify all devices are communicating properly. When testing communication between the Gateway and Node, all
radios and antennas should be at least two meters apart or the communications may fail. This table lists the LED behavior for the Gateway models with two LEDs.
LED 1
LED 2
Gateway Status
(solid green)
Power ON
(flashing red)
(flashing red)
Device Error
SureCross Performance Gateway
P/N 155861 Rev. D
www.bannerengineering.com - tel: 763-544-3164
5
