B&R PROVIT 3030, User Manual

Page: 40 / 64

40
4.4 MONITOR MODULE
Air ventilation
4.4.1 FUSES
Monitor and CPU fuses are installed for the PROVIT 3030 delivery.
- Monitor fuse 2 A / 250 V
- CPU fuse 5 A / 250 V
Only fuses with the same specification may be used as replacements.
4.4.2 VOLTAGE SELECTION SWITCH
The PROVIT 3030 industrial PC can be switched from 220 VAC to 120 VAC for use in different areas. The
switch is set to 220 VAC as a standard for delivery. Before starting up be sure to check for the proper voltage
selection depending on the area of the world that you are in.
4.4.3 POWER CONNECTION
A power cable is included with the delivery. On the device end the proper connector with screws for fastening
is attached. The other end is left up to the user whereas it can be terminated with a conventional plug or can
be wired in directly.
Attention:
- Only mains plugs with a proper ground termination may be used.
- Terminations may only be wired by authorized, qualified personnel.
- Know the regulations regarding electronic installations in your area.
Monitor fuse
Hand screw
Voltage selector switch
Power
Ground connection
CPU fuse
Hand screw
Contrast
Brightness
Horizontal position
Vertical position
atpr2.p65 13.10.00, 14:54 40