Software • BIOS options
206
Panel PC 800 User's Manual V1.30
1.4.11 Remote access configuration
Advanced
Configure Remote Access type and parameters
Select Remote Access
type.
Serial Port BIOS Update [Disabled]
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Remote Access [Disabled]
BIOS SETUP UTILITY
v02.59 (C)Copyright 1985-2005, American Megatrends, Inc.
Figure 112: 945GME Advanced Remote Access Configuration
BIOS setting
Function
Configuration options
Effect
Enabled
Enables this function
Remote access
Enables/Disables the remote access function
Disabled
Disables this function
COM1
Enables the COM1 interface as a remote ac-
cess interface
Serial port number
This option is used to configure the serial inter-
face as long as
Remote access
is not set to "Dis-
abled".
COM2
Enables the COM2 interface as a remote ac-
cess interface
Displays the logical address and interrupt for the
serial port as
Remote access
is not set to "Dis-
abled".
None
-
Serial port mode
Defines the serial port transfer rate as long as
Re-
mote access
is not set to "Disabled".
115200 8,n,1
57600 8,n,1
38400 8,n,1
19200 8,n,1
09600 8,n,1
Sets the value manually
None
Operates the interface without transfer control
Hardware
Uses hardware for interface transfer control.
This mode must be supported by the cable.
Flow control
Determines how the transfer is controlled via the
interface
Information:
The setting must be the same on the ter-
minal and the server.
Software
Uses software for interface transfer control
Disabled
Disables redirection after startup
Boot loader
Enables redirection during system startup and
when charging
Redirection After BIOS
POST
Configures redirection after startup as long as
Remote access
is not set to "Disabled"
Always
Keeps redirection enabled permanently
Terminal type
Configures the type of connection as long as
Re-
mote access
is not set to "Disabled".
Configures the connection type manually
Enabled
Enables this function
VT-UTF8 combo key sup-
port
This option can be used to enable VT-UTF8 com-
bo key support for ANSI and VT100 interfaces as
long
Remote access
is not set to "Disabled".
Disabled
Disables this function
No delay
No delay
Sredir memory display de-
lay
This option can be used to set the memory out-
put delay as long as
Remote access
is not set to
"Disabled" (Sredir -> serial redirection).
Delay 1 sec, Delay
2 sec, Delay 4 sec
Sets the value manually
Enabled
Enables this function
Serial port BIOS update
Loads updates to the processor via the serial in-
terface during system startup
Information:
Disabling this option reduced the boot
time.
Disabled
Disables this function
Table 160: 945GME Advanced - Remote access configuration - Configuration options