Phaesun GmbH
· Brühlweg 9 · 87700 Memmingen · Germany · T49 (8331) 990 42 - 0 · T49 (8331) 990 42 - 12 · [email protected] ·
www.phaesun.com
St
an
d 1
0/20
13 J
AZ
St
an
d 1
0/20
13 J
AZ
Solar Modul Ascent 45W, Solar Modul Ascent 21W:
flexible, lightweight, thin-layer solar module 12 V, fluoropolymer for the use
with 12 Volt rechargeable batteries
This manual includes information about safety, operation, capacity and main-
tenance of the module, as well as technical instructions which you should
make yourself familiar with before you use your solar panel! Please read
these instructions carefully before installation!
Safety Warnings
This manual does not list all precautions needed for safe work.
Follow local guidelines.
Modules may not be folded or creased during handling and storage. They
may only be rolled up “cell” side out to a diameter of no less than 40 cm
(15 inches)
Folding and excessive bending will cause cracks and internal short circuits
which will create locally over currents causing overheat and melting the
encapsulation materials
Voltage of a single module is not dangerous.
Never connect more than 2 modules in series (24 V-systems)
Work under dry conditions with dry tools.
Modules exposed to sunlight produce DC electricity. Live parts may cause
electric shock. Avoid contact with the metal terminal leads in order to
reduce the risk of electrical shock.
Use electrically insulated tools when wiring modules.
Connect your system in a carefully vented environment and make sure
there are no highly inflammable gases or vapours existing.
Observe proper polarity when connecting the module into an electrical
circuit. Reverse connection will damage the module and may result in fire
and/or personal injury (Figure 1).
Do not use non-rechargeable batteries!
Please observe during work with batteries and electrical equipment the
industrial standards and safety instructions of respective manufacturers!
Avoid partially shading modules under load to prevent hot spots and/or
reduction in power.
Artificially concentrated sunlight shall not be directed onto the module.
Do not carry the module by the wires.
Do not cut, scratch, or puncture the Module.
When trimming the adhesive from around the perimeter of the module,
do not cut the module in any way.
Do not stand or walk on the module.
Do not immerse unconnected connectors in liquid.
Do not drop or allow objects to fall onto the Module.
Do not attempt to open, or otherwise dismantle the junction box.
Installation
1. Choose an appropriate position to assemble your panel on a solid surface.
2. Fix the module in a position that ensures the cell surface is inclined
towards the sun and choose a location where the solar module is able to
absorb as much sunlight as possible. Direct the panel to the south side to
achieve the best possible charging performance.
3. Connect the solar panel over a charge controller (not included in delivery)
with your battery.
Mind the correct polarity (+) and connect the terminal of the extension ca-
ble correspondingly with the positive battery pole, the charge controller, or
any other optional 12 V device and the (–) terminal with the negative pole
Reverse connection will damage the module and may result in fire and/or
personal injury
During installation, roll modules up “cell” side in a diameter of no less than
80 cm (30 inches)
Do not immerse your panel entirely and over a longer period in water
Modules may only be rolled up
“cell” side out to a diameter of
no less than 40 cm (15 in)
flexible
Modules may not be
folded or creased during
handling and storage
water-resistant
Safety and Installation Manual
Solar Modul Ascent 45W / 21W
