Installation and wiring
Automation Panel 5000 User's manual V2.11
161
5.5.10 Removing the expansion unit/cover
The following requirements must be met:
•
All connected cables must be disconnected.
•
The Automation Panel must no longer be installed on the VESA or swing arm system.
1. Disconnect the power supply cable to the Automation Panel (disconnect the power cable!). Disconnect from
all sources and poles!
2. Carry out electrostatic discharge at the ground connection.
3. Place the Automation Panel on a clean, flat surface.
4. Remove the back cover of the panel by removing the 14 Torx screws (T20).
5. If an expansion unit is installed, the cables for the circuit board and front USB interface must be disconnected
from the panel's circuit board.
6. Remove the 12 nuts (M3) indicated in the following figure and remove the expansion unit / expansion cover
from the panel.
Information about impermeability
Warning!
Failure to follow instructions can result in damage to property.
•
The gasket must be inspected before installation or reinstallation and at regular intervals according to the
requirements of the operating environment.
•
Replace the entire device if inspection reveals visible scratches, cracks, dirt deposits or excessive wear.
