Request for use on
Disclaimer
● This product, which is one of those high frequency utilization equipment of Radio Law.
In the case of using in Japan, please apply for a permission application for high frequency utilization
equipment permission to Ministry of Internal Affairs and Communications.
In the case of using the product out side Japan, please take appropriate action after confirming by
yourself the standards and regulations to which the customer’s system should conform. If you have
any questions about the application, please contact our sales department.
● For the control communication device that is installed in the product, there is no need for (diplo-
ma) radio station authorization of the Minister as it corresponds to“ a weak radio station (weak radio
equipment)”to.
However, please be careful when operating it as it may affect electronic devices (sensor devices) and
medical devices (pacemakers, etc.).
● In principle, repairs will be charged in the event of failure or damage caused by fire, earthquake, acts by
a third party, other accidents, intentional or negligent use by the customer, misuse, or use under abnormal
conditions.
● The Company is not liable for any incidental damages (loss of business profit, etc.) resulting from the
use or inability to use this machine.
● If this unit is used for purposes other than battery charging, we cannot guarantee it.
※ Specifications subject to change without notice.
If there is a point of notice about the contents of this document, hope you'll give me your contact us, thank you.
normal open
normal close
12V type RCS600-CA12
RCS600B-CA12
24V type RCS600-CA24
RCS600B-CA24
48V type RCS600-CA48
RCS600B-CA48
normal open type: external connection pin (Pin) is arranged as shown on the right. When
the non-voltage contact is ON, charging starts, and when it is OFF, charging stops. To
start charging, it is necessary to turn it on on the ON connector, separate wiring, or on the
control side. Details are described on page 17.
normal close type: the external connection pin (Pin) is arranged as shown on the right.
When the non-voltage contact is OFF, charging starts, and when it is ON, charging stops.
Details are described on page 17.
Pin1.charge start
Pin14.GND
dry contact
internal circuit
internal circuit
normal open
Pin1.charge stop
Pin14.GND
dry contact
normal close
● The charging unit of this product have two specifications, normal open type and normal close type.
Attention
Do not use under conditions with excessive vibration or impact
Using it beyond the conditions may cause an accident, malfunction or fire. Be sure to use it within
the specifications.
Do not use in a state where it is filled with dust containing oil and moisture and accumulated.
Accumulation inside the device may cause a malfunction or fire. Clean it regularly or put it in a
case to protect it.
