- 11 -
Wireless charging system 210W specification
4.Notes at the time of installation (at the time of attachment)
● Notes at the time of installation of the charging unit and power supply unit
・Location
In order to obtain a good cooling effect, please keep as shown below the separation distance between
the surrounding body so as not to block the airflow.
・For the transmission distance and center off-set between the heads
The permissible center off-set of the feed head and charging head, please be installed so that the to-
tal (X + Y) axis deviation of the width of the X-axis · Y-axis is the following table. (For example, X-axis
equals a 10mm, Y-axis 0mm. If X-axis is 5mm, Y-axis is less than 5mm.)
If the product is used outside the range, you may or equipment degradation of transmission efficiency
may be damaged.
10
ｃｍ
以上
5
ｃｍ
以上
5
ｃｍ
以上
5
ｃｍ
以上
B
B
軸ズレ XまたはYどちらか１方向 (mm)
A
B
C
Metal
Metal
G
Direction Distance
G
≦ 10mm
X+Y
X 軸方向
Y 軸方向
More than 5cm
More than 5cm
More than 10cm
More than 5cm
X-axis direction
Y-axis
direction
● Notes of each head when mounting
・Influence of surrounding metal
To avoid influence of surrounding metal, keep minimum spacing.
Remove metal chips or metallic debris on the active surface.Metal chips or metallic debris generate
may damage to device or cause unexpected trouble.
Type code
A(mm)
B(mm)
C(mm)
RCS240AH
100
40
45
RCS240PH
