- 15 -
Wireless charging system 210W specification
Single phase 100V,
200V
To the power supply
side
Power Supply unit
Charging unit
(1)24V lead battery
(1) Parts of the dotted line (External device communication cable and 24V lead batteries) within the product
is not included with this product. They are contents prepared and processed of a visitor.
(2) That the protection function is turned on, is 40.5 ℃ or more. (The installation situation, there is a differ-
ence about ± 2 ℃ .)
In addition, I have you use the attached article always, thermistor put it on the side of 24V lead
batteries Please attach. In that case, please do not touch any terminal.
(3) Each cable, please connect with the specified length. You may receive an error due to the output such as
a decrease occurs.
Connection diagram
Passive Head
Active Head
Power cable
Output cable
(2)Thermistor with Cable
(1)External
device commu-
nication cable
(AWG28 ～ 16)
(1)External device
communication cable
(AWG24 ～ 16)
Details of the charging unit input and output
24V lead battery
Load
Thermistor
フェライトクランプ
フェライトクランプ
フェライト
クランプ
電源ユニット
充電ユニット
給電ヘッド
受電ヘッド
Mounting of the ferrite clamp
The installation of the bundled ferrite clamp is necessary
in addition to the upper figure to meet a standard of the
EMC(IEC61000-4-3).
Please attach a ferrite clamp to a power cable by 2 turns
with the following points each.
・It is one within 20cm from a power supply unit
・It is one within 20cm from a power supply unit to the
power cable of the active head.
・It is one within 20cm from a passive head to the power
cable of the passive head.
Charging
unit
Power
Supply
unit
Passive Head Active Head
ferrite clamp
ferrite clamp
ferrite
clamp
