- 14 -
Wireless charging system 210W specification
● Power supply unit side (RCS240-AC1)
Ｐ ＬＭＨＦＣＩＮ
①
②
③
④
⑤
Signal type
LED
Contents
Input
Start-up signal
P
Shorting this signal, make the power supply to the active
head.Then, the active head starts oscillating, and then
start the communication signal and power transmission
to the passive head. If you do not have a Passive head, I’ll
intermittent oscillation.
Output Voltage monitor signal L
L
It needs charging for charging amount is reduced.
(Charging aim:less than about 50%)
Voltage monitor signal M
M
If the charge has been reduced somewhat. (Charging
aim:about 70%)
Voltage monitor signal H
H
It is almost fully charged. (Charging aim:about 90%)
Float charging signal
F
It turns on, when a charging current value turns into a rat-
ed value.
Charging signal
C
I will turn OFF during charging ON, in charge cut-off and
float charging start.
Inzone signal
I
I will if ON is in the transmission area within the Active
head / Passive head.
Error signal
N
It turns on, if a battery error occurs.
(7.About the function P.19 reference)
● Maximum load current : 50 m A
● Maximum load voltage: 30V
PS
PS
ショートにて動作
P
P
L
+
L
-
M
+
M
-
H
+
H
-
F
+
F
-
C
+
C
-
I
+
I
-
N
+
N
-
1
2
3
4
5
6
7
8
9 10 11 12 13 14
① Connector for the active head (Signal)
② Connector for the active head (Power)
③ Start-up signal
④ Each output signal
Each output signal is an open connector.Please connect the load, such as not to exceed
the maximum load voltage and current of the following whenever you want to connect.
Please be careful so as not to short.
※ It is the ON / OFF signal of the power supply of the Active
Head.To do with the ON / OFF operation with separate
switch, please use always ON.
(It is a jumper with factory)
P
P
Internal circuit
Power supply unit
Vcc
Ｉ
To fit in each condition,
Please select the load
Load
〇 +
〇－
Internal circuit
Power supply unit
<Input signal pin assignment>
⑤ LED