B&K AVR 707, User Manual

Page: 40 / 80

31
Operation and Control
AM / FM Tuner Operation
All TUNER operations require the receiver source be set to TUNER. Press the FM or AM button on the remote or select AM or FM input
using the front panel to access the tuner.
Manual Tuning - From the remote control or the front panel,
tap the Tune + / - arrow to tune one frequency step at a time and Seek +/- arrow
to automatically seek up or down to the next available strong station. Very strong stations may cause seeking to stop one step away from the sta-
tion’s actual frequency. Check one step above or below if you are not sure. Your favorite stations may then be saved into one of the 40 Tuner
Preferences .
Direct Frequency Entry Tuning - To directly recall a tuner frequency, press the FM or AM button on the SR 10.1, then enter the fre-
quency of the station within the next 3 seconds.
Example - Button press steps for directly entering the radio station for 103.3 FM = FM - 1 - 0 - 3 - 3
Headphone Operation
Headphone mode allows output of the source selection using a set of headphones. The headphone jack uses a 1/4” (6.3mm) stereo jack. From the
remote control select STEREO 0. SURROUND - 0 is identical to STEREO-0. To select headphone mode from the front panel, select a source, press
the MODE button. Press the UP or DOWN arrows to step through until the receiver switches into headphone mode. When in headphone mode, the
rear panel 1/8” mini-jack labeled AMP Enable Output may be used to turn off an external power amplifier of subwoofer. This feature allows your receiv-
er to turn off external amplifiers or powered subwoofers with compatible 12VDC CONTROL inputs. The receiver will mute the surround output chan-
nels when in headphone mode.
While in 'HEADPHONE', equalization features of the receiver remain operational. The unit will stay in headphone mode until a different speaker selec-
tion is made. This feature allows the 'Headphone' selection to stay in effect until the unit is put into sleep.
WARNING: In order to provide full range audio to your headphones, it is necessary that we override the bass management processing in
your receiver. If you are using external amplifiers or powered speakers that are not connected to the receivers Amp Enable Output, then
full frequency response audio will be sent to your front left and right speakers. If you have small front speakers we strongly suggest you
manually turn off your external amplifiers or powered speakers before selecting 'HEADPHONE' operation. Otherwise speaker damage may
occur.
Control Out On / Off
For use with 12VDC trigger of an external device via the rear panel 1/8” mini-jack Control Out connector, using the SR 10.1 remote, from
the MAIN PAGE select VIDEO, then select the CTRL+ or CTRL- device button to set OFF / ON.