Bandit
25
MODEL SG-40
MAINTENANCE
1.
Measurethedeflectionwith40-50lbs.(18.1-
22.7kg)offorcewith1/2”deflection.
2.
If the deflection is not 1/2” tighten or loosen
the nuts on the adjuster bolt (shown in green
in Figure 1). Note: you will need to adjust the
adjuster bolt on the opposite side of the track.
3. Check the tension again and adjust as needed.
TRACK TENSION
Before attempting any type of maintenance,
disengage clutch or cutter wheel engagement, wait
for the cutter wheel to come to a complete stop, turn
offengine,removetheignitionkey,makesurethe
ignition key is in your possession, disconnect the
battery, and install the cutter wheel lock pin.
Avoid moving parts. Keep hands, feet, and clothing
away from power driven parts. Keep all guards and
shields in place and properly secured.
Keep hands clear of pinch points.
SAFETY INSTRUCTIONS
DANGER
Figure 1
1/2”(12.7mm)deflectionat
40 - 50 lbs. (18.1 - 22.7 kg) of force.
Adjuster Nuts
NOTICE
Make sure the distance on the track roller
adjuster bolt is the same on both sides of each track.
Same
distance on
both sides
Summary of Contents for SG-40
