Bandit
24
Copyright 3/17
MODEL SA-25
Lead Tooth “Shorts” ‑ Hex:
900‑9912‑24
Side Tooth “Longs” ‑ Hex:
900‑9912‑23
Pocket without locator pin ‑ Hex: 900‑9912‑26
Pocket with locator pin ‑ Hex: 900‑9912‑25
Tooth Nut:
900‑9909‑99
MAINTENANCE
NEW RIVER “REVOLUTION” CUTTER WHEEL
Lead Teeth
Side Teeth
DO NOT OPERATE MACHINE WITHOUT A FULL SET OF TEETH. OPERATING MACHINE WITHOUT
A FULL SET OF TEETH CAN CAUSE EXCESSIVE VIBRATION AND PREMATURE BEARING FAILURE.
Use only original equipment manufacturer’s teeth. The use of any other aftermarket teeth may cause damage
or premature failure to the drive train.
There are thirty-two (32) teeth, thirty-two (32) tooth nuts, and twenty-four (24) pockets to a complete set.
Twenty-four (24) teeth: eight (8) lead teeth (Shorts) and twenty-four (24) side teeth (Longs). Twenty-four (24)
pockets: twelve (12) pockets without locator pin and twelve (12) pockets with locator pin.
A locking pin is provided to hold the cutter wheel in position during tooth removal and reinstallation. Locking
pin will only lock on outer teeth.
DANGER
!
NEVER USE HAND ON CUTTER WHEEL TO HOLD IN PLACE WHILE CHANGING TEETH. BE SURE TO
REMOVE LOCKING PIN BEFORE OPERATING THE MACHINE.
NOTICE
Do Not operate machine with extremely worn or broken teeth.
Inspect teeth, nuts and pockets for damage and
replace as required.
When replacing teeth, always replace new teeth
across from each other (180°) in order to prevent
vibration.
Replacement teeth must be carbide tipped and of
like design as provided with the machine.
To make sure the correct tooth pattern is used, make
sure a pocket with a locator pin is used on a station
with a locator pin hole. Use the pockets without the
locator pin on a station without the locator pin hole.
When replacing complete set of teeth, be sure to
duplicate original factory tooth arrangement, with the
carbide tip facing the cutter wheel rotation. Typically
a 15/16” socket is required to change or torque the
teeth. Torque Lead Teeth to 200 ft.-lbs. (271 Nm) and
Side Teeth to 125 ft.‑lbs. (169 Nm).
TOOTH ARRANGEMENT
