Bandit
21
Copyright 3/17
MODEL SA-25
MAINTENANCE
BOLT TORQUE CHART
(THESE TORQUES ARE BASED ON DRY, CLEAN THREADS)
DESCRIPTION
BOLT SIZE
TORQUE (FT.-LBS.) TORQUE(Nm)
Before tightening bolts be sure you have the correct size bolt for the correct amount of torque.
Use only factory approved knives and hardware.
Cutter Wheel Revolution Lead Tooth Nut
5/8”‑18 NF
200
271
Cutter Wheel Revolution Side Tooth Nut
5/8”‑18 NF
125
169
Stub Shaft
1/2”‑13 NC
75
102
Stub Shaft Brace
5/8”‑11 NC
170
230
1. Grease cylinder lug pin bushings with 1 to 2 shots.
2. Lubricatesteelfrictionareas:pivoting,hinged,sliding,&rotatingareas
(i.e. cutter wheel guard, etc).
WEEKLY CHECK LIST
OK Repaired
Each week these checks must be made:
Each day before starting your machine these checks must be made:
1. Check the safety decals, replace if damaged.
2. Check,maintain,andserviceallsafetyequipmentforproperoperation.
3. Check entire machine for loose nuts, bolts, and components.
4. Check all guards to make sure they are tight and securely in place.
5. Check the condition of the cutter wheel and teeth pockets.
6. Check the condition of the cutter teeth, pockets, and hardware.
7. Properly torque cutter wheel pocket bolts.
8.
Greasethetopandbottomswingpivotbushingswith1to2shots.
9. Checkallhoses,fittings,lines,andtanksfordamageandfluidleaks.
10. Check around the entire machine for any foreign objects, tools, cans, saws, etc.
11.Reviewallsafetyproceduresondecals,frommanual,andfromvideo.
12.Wearallapplicablesafetyequipment:hardhat,faceshield,gloves,eye
protection, ear protection, etc.
13.Make sure the forestry approved door and window on the skid steer is in good
condition.
14. Make sure FOPS cab on the skid steer is in good condition.
15. Follow all daily start up and maintenance procedures for the skid steer.
16. Remember to check EVERYTHING on the checklist.
DAILY START UP & MAINTENANCE CHECK LIST
OK Repaired
