Bandit
Copyright 1/07
PAGE 0
MODEL 3400T
PROBLEM
POSSIBLE CAUSE
SOLUTION
Engine will not start. 1. Loose ground cable.
1. Clean and tighten.
(See Engine MFG.
. Loose hot cable.
. Clean and tighten.
manual for further
. Dead battery.
. Recharge or replace.
information.)
4. Cutter wheel was engaged before the 4. Switch cutter wheel to off, make sure
machine engine was started.
key switch is off, and then restart the
machine.
. Batteries in remote are dead.
. Replace.
6. Kill switch on remote is activated.
6. Twist and pull out.
Cutter wheel
1. Tooth missing.
1. Replace missing teeth.
vibration.
2. Pocket out of balance.
2. Always replace pockets in pairs
across from each other.
3. Improper tooth arrangement.
3. Install correctly with like pairs of
teeth directly across from each other.
. Loose hydrostatic motor bolts.
. Tighten and retorque.
. Bad hydrostatic motor.
. Replace.
Cutter wheel
1. Bad pocket.
1. Replace pocket.
throwing teeth.
2. Dirt in pocket.
2. Clean pocket and replace missing
teeth.
Cutter wheel
1. Operator hitting rocks.
1. Avoid rocks, stone, etc.
breaking teeth.
Cutter wheel stops
1. Bad hydrostatic motor.
1. Replace.
turning.
. Bad hydrostatic pump.
. Replace.
. Low hydraulic pressure.
. Reset pressure.
. Debris wedged around cutter wheel.
. Clean out debris.
Bearing will not
1. Grease fitting clogged.
1. Replace.
take grease.
Machine will not
1. Weak or dead batteries in remote.
1. Replace.
respond to remote.
2. Remote not turned on before starting
2. Turn off engine, turn remote power
the machine engine.
on, and then start engine.
. Machine is out of range of the remote. . Move closer to the machine and
make sure there are no obstructions
between operator and machine.
4. Broken or damaged antenna
4. Replace.
. Remote power switch was turned off.
. Shut down and restart the machine.
TROUBLE SHOOTING
MAINTENANCE SECTION