Bandit
62
Copyright 6/18
MODEL 2590
Checking clutch engagement torque on Twin Disc 318:
1. Follow all pre-maintenance shut down procedures.
2. Remove 3/8” bolt, lock washer, fl at washer, large retaining fl at washer and 1-1/2” diameter spacer.
3. Remove engagement handle off from engagement shaft.
4. With hardware removed a 1-1/2” 6 point socket will go the engagement shaft.
5. Check engagement torque with a torque wrench, suggested torque values will be found on the clutch
inspection plate.
6. Please refer to the Twin Disc service/maintenance manual if there are required adjustments needed to
meet the torque values listed on the inspection cover.
7. Reinstall the clutch handle and hardware that was removed once clutch engagement torque check is
completed.
DANGER
!
TWIN DISC SP318 CLUTCH HANDLE & TORQUE
Remove hardware and install
socket here to check torque.
Before attempting any type of maintenance, disengage clutch, wait for the disc/drum to come to a complete
stop, turn off engine, remove the ignition key, make sure the ignition key is in your possession, install the
disc/drum lock pin, wait 2 minutes then disconnect the battery.
MAINTENANCE