Bandit
65
Copyright 6/18
MODEL 2590
MAINTENANCE
1. Follow all pre-maintenance shut down procedures.
2. Remove the drive chains from the left side of the bottom feedwheel shaft.
3. Remove the sprockets and bushings from the left side of the bottom feedwheel shaft.
4. Block the bottom feedwheel up and unbolt the bottom feedwheel bearings.
5. Remove the block and drop the bottom feedwheel straight down until it hits the frame.
6. Remove both feedwheel bearings from the bottom feedwheel shaft.
7. Swing the right side end of the bottom feedwheel forward towards the engine, until it clears the frame.
8. Drop the right side end of bottom feedwheel down and out between the axles.
BOTTOM FEEDWHEEL REMOVAL
Figure 1
Remove the drive chains, sprockets, and bushings.
DANGER
!
Before attempting any type of maintenance, disengage clutch, wait for the disc/drum to come to a complete
stop, turn off engine, remove the ignition key, make sure the ignition key is in your possession, install the
disc/drum lock pin, wait 2 minutes then disconnect the battery.