Bandit
32
Copyright 6/18
MODEL 2590
CONTROLS
DANGER
!
Before attempting any type of maintenance disengage clutch, wait for the disc/drum to come to a complete
stop, turn off engine, remove the ignition key, make sure the ignition key is in your possession, install the
disc/drum lock pin, wait 2 minutes and then disconnect the battery.
This will normally be located near the fender of the machine on right side. It can be recognized by a valve
with two solenoids bolted on a square block. The solenoid is approximately 2 1/2” (63.5mm) diameter x 2 3/4”
(69.9mm) long. It will have two wires coming from it or on the newer machines it will have a connector with a
light screwed to it. The feed coil must have power (indicated by the light in the connector) for the feedwheels
to feed and pull material in.
Solenoid
is Electronically activated to produce a magnetic pull which shifts the spool inside the hydraulic valve.
Shifting of the spool changes oil flow direction from operating forward or dumping oil to tank.
High or HI
is the setting when the feedwheels will turn back on (feeding operation).
Low or LO
is the setting when the autofeed will reverse (if equipped) the feedwheels and then turn the
feedwheels off.
Back
Amount of time in seconds the feedwheels will back the wood away from the cutter disc/drum. Normally
this will be set at .3 seconds.
TONGUE JACK - PINTLE HITCH
Tongue Jack Control Valve:
NOTE: Remove the lock pin BEFORE operating this function.
The tongue jack control valve operates the tongue jack cylinder. To raise the front of the machine, push the
control handle up. To lower the front of the machine, pull the control handle down. The tongue jack control valve
is in the off position in the center position.
Dual Coil Reverse Valve:
900-3920-01
900-3949-27
DUAL COIL REVERSE VALVE