F
Only one input can be determined as tamper input.
Properties of the tamper input:
Activation of the tamper input:
Only voltage level control is possible. 0 V is factory (fixed) set as active (tamper problem).
4
As long as this input is active, the relay [Tmpout] will be switched onto rest situation
(contact Ta and Tb open).
Internal siren:
The unit 240PB comes with an integrated internal siren. This siren is automaticaly
activated with different modes (each mode has its own siren or beep sound). The
“internal siren”-function gives you the possibility to control this siren also from “outside”
through a selectable input.
Properties of the "internal siren” input:
Has the priority on all other siren sounds (with the exception of fire mode on).
4
The volume of the internal siren can be set:
-
;
speaker -
;
internal siren.
4
The internal siren sounds as long as the internal siren input is active, but the internal
Bandit-electronics will reduce the audio volume after 3 minutes of sounding, to 50%
(battery saving).
Activation of the internal siren input:
Only voltage level control is possible. Depending on the software settings, no voltage
(0 V) or 12 V can be set as active.
External alarm:
This special input function offers a fine solution for some special requests to the security
installer. It’s obvious a
BANDIT
-fog generator is installed in locations where “ram raid”
sensitive, high value goods should be protected. Sometimes, there is also the need to
overview and guard an external contact.
For example: a min/maximum temperature thermostat in a computer-server room,
whereby the over or under temperature limit exceeding has to be logged, mains tension
independent. As a warning, the siren has to sound and a contact has to report the
technical alarm.
The input function “external alarm” could offer a very cheap and fine solution for such a
problem.
BANDIT
240
PB
v.
408
p. 19 - Inputs - Functions
