B&G Zeus2 series, Installation Manual

Page: 21 / 50

| 15
Software setup | Zeus2 Installation Manual
Time and Date
Confi gure time settings to suit vessel location.
Power Control setup
Determines unit response to signal applied to yellow wire of power cable.
These settings do not require adjustment if the yellow wire is connected to ignition or to a
stand-alone switch that applies 12V/24V.

Note: The System Controls menu will not display the ‘Power Off ’ option when unit is confi g-
ured as slave. To power down device, the master device must be powered down, or system
power removed.
Source selection
Data sources provide live data such as GPS position, heading, wind speed, and temperature.
The data may originate from modules internal to the device (eg internal GPS), or external
modules connected via NMEA 2000 or NMEA 0183. The internal ‘virtual’ devices typically
include echo, MFD, Navigator, Pilot Controller, and iGPS. When a device is connected to more
than one source providing the same data, the user has the fl exibility to choose the prefered
source. Before commencing with source selection make sure all external devices and the
NMEA 2000 bus are connected and are turned on.
Auto Select
The Auto Select option will look for all sources connected to the device. If more than one
source is available for each data type, selection will be made from an internal priority list. This
option will be suitable for the majority of installations.
Manual source selection
Manual selection is generally only required where
there is more than one source for the same data,
and the automatically selected source is not the
one desired.