10 / 25
51336-005 en/2022-03
1
electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • [email protected]
1.5
Warnings and safety precautions
General
• In accordance with its intended use and these user instructions, the shaking device
must only be used together with a SONOREX DIGITEC DT 1028 F ultrasonic bath.
Consequently, the safety information in the SONOREX DIGITEC F series user
instructions also applies.
• Keep the shaking device out of the reach of children and also of persons who have
not been instructed in their operation by reference to these instructions.
• Do not insert any objects in the coupling opening.
• The
shaking device adheres to prescribed EMC limit values, such that it can be
assumed that the electromagnetic radiation emanating from the unit is harmless to
humans. However, a binding statement for wearers of implants can only be made
at the place of work and together with the implant manufacturer. In case of doubt,
information regarding the allowable electromagnetic exposure level is to be obtained
from the implant manufacturer.
• Keep the surface of the device and the controls clean and dry!
• For
cleaning and disinfection, only use cleaning agents and surface disinfectants
which are suitable, approved, tested and compatible with the materials.
• The user instructions with their safety instructions must remain with the unit and
must be observed without fail!
• If the shaking device is passed on, the user instructions with the safety instructions
must also be handed over.
Damage and defects
• If any damage is identi
fi
ed, do not connect the shaking device up to the power
supply.
• In
the event of defects, disconnect the mains plug immediately.
•
Repairs are only to be conducted by authorised skilled personnel or by the
manufacturer!
•
Defective parts may only be replaced with original parts.
Operation and transport
• Only plug the shaking device in to an outlet with a grounded socket.
•
Observe ambient conditions, see Section 1.4.
•
Only insert and remove samples with the shaking device switched o
ff
.
• Secure
fl
asks in the roller carriage prior to switching on the shaking in order to
ensure that they do not move and/or topple over.
• To avoid damage and environmental risks as well as damaging the samples,
suitable, sealed
fl
asks should be used.
• To avoid wave pounding, maintain the
fi
lling level in the ultrasonic bath and adjust
the power setting to the number of samples.
• Do not touch any parts of the device or reach into the device when shaking is in
progress.
