23346-002 en/2023-03
9 / 38
2.9 Erosion of the oscillating tank
The surface of the oscillating tank is subject to erosion. How quickly this erosion takes
place depends on the usage of the device. The erosion leads to leaks in the oscillating tank.
Bath liquid can thus leak into the interior of the device. Moisture on electrical components
can lead to an electric shock or fire.
• Stop using the device if you notice a leak. Disconnect the mains plug immediately.
Empty the oscillating tank.
You can extend the lifespan of the oscillating tank by observing the following instructions:
• Replace sonication fluid that is visibly contaminated by particles.
• Only use demineralised water (DI water) with an ultrasound-compatible agent.
• Do not use chemicals that contain or release chloride ions in the oscillating tank.
This is the case with some disinfectants, household cleaners and dishwashing detergents.
Chloride ions will corrode stainless steel.
• Only use the device with accessories that are suitable for the device and the objects
to be treated, e.g. a basket. Do not place any objects to be treated directly on
the bottom of the oscillating tank. An overview of suitable accessories can be found
in chapter
.
2.10 Preventing damage to the device
• Only use aggressive agents in inset beakers or insert tubs. When working with
aggressive agents, avoid splashing in the contact liquid or on the stainless steel surface.
Replace contaminated sonication fluid immediately. Clean surfaces and wipe them dry.
• The use of highly acidic agents can corrode the ball of the ball valve. The ball valve will
leak. If the use of a strongly acidic detergent cannot be avoided, use a stainless steel
ball valve.
• Do not operate the device without sonication fluid in the oscillating tank. Make especially
sure that the heater is switched off when the oscillating tank is empty. The fill level must
always be at or slightly above the filling level mark.
Safety