13 / 42
51376-012 en/2022-09
1
electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • [email protected]
• Liquids must not penetrate the inside of the ultrasonic converter or ultrasound generator.
• Never twist the ultrasonic converter's housing toward the aluminium cylinder
(ultrasonic oscillating system). The ultrasonic oscillating system and its electrical
connections would be damaged as a result.
• Do not operate the device without supervision.
• The ultrasonic homogeniser is only intended for use by quali
fi
ed personnel.
• In isolated cases, unfavourable operating conditions may result in EMC disruptions
that may a
ff
ect devices that are in the direct vicinity.
• During
operation, portable or mobile HF communication systems in the vicinity
of the ultrasonic homogeniser should be turned o
ff
- operation may be disrupted.
Damage
• If damage to the ultrasonic homogeniser is detected, do not connect the ultrasonic
homogeniser to the mains.
• In the event of defects, disconnect the mains plug immediately.
•
Repairs must only be conducted by authorised skilled personnel or by the manufacturer.
•
Defective parts must only be replaced with original parts or parts of the same quality!
2 Preparation
Carefully unpack the ultrasound generator, ultrasonic converter and accessories, and inspect
them for completeness or possible transportation damage. If damage or defects are ascertained,
notify this to the forwarding agent and the supplier immediately and in writing.
Before start-up, the ultrasonic homogeniser should be allowed to stand for 2 hours at its operating
location so that it can adjust to the ambient conditions.
Summary of Contents for Sonopuls HD 4050
Page 42: ......