12 / 38
51406c GB/2019-07
1
electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • [email protected]
Advice for the medical and laboratory
fi
eld
• The homogenizer is exclusively intended for use by skilled medical personnel.
• It may generate radio interferences or disrupt the operation of devices nearby. It may be
necessary to take remedial measures such as realigning the device or recon
fi
guring the
homogenizer or the shield.
• During
operation, portable or mobile RF communication systems in the vicinity of the
homogenizer should be turned off - operation may be disrupted.
Damages
• If
damage to the homogenizer is detected, do not connect the homogenizer to the mains.
• In the event of malfunction, disconnect the mains plug immediately.
•
Repairs are only to be conducted by authorised skilled personnel or by the manufacturer.
• Defective parts must only be replaced with original parts or parts of the same quality!
2
Preparation
Carefully unpack the HF generator, ultrasonic transducer and accessories, and inspect them for
completeness or possible transportation damages. If any damages or defects are found, these are
to be immediately noti
fi
ed in writing to the transportation company and to the supplier.
Before startup, the ultrasonic bath is to be left to stand at its operating location for 2 hours so that
it may adapt to the ambient conditions.
2.1
Scope of delivery
The scope of delivery will depend on the size of the order. However, it will generally include the
following parts:
1
HF Generator GM mini20 with holder and mains cable - see delivery note
1
Ultrasonic transducer UW mini20
1
Probe
1 Instructions for Use
Additional accessories according to order - see delivery note
2.2
Set-up / assembly
Place the HF generator atop a
fi
rm, level and dry surface. In doing so,
•
do not group it or stack it over other electric or non-electric devices.
•
Guard against moisture and wetness - risk of electric shock.