2.3 PLACE DOOR ON BRACKETS
a) Check the axle length and cut if sideroom is limited. Before cutting, make sure the fl oating axle is free and centred. Centre will
be found by rotating the axle a quarter turn in either direction then releasing . With centre found, make a clear mark on the axle
against the hub for later reference.
b) Lift door onto the brackets (the right way round so that the door will roll down from the front of the opening). Immediately loosely fi t
the “U” bolts, saddles, washers and nuts to the brackets in position shown. Fitting the ‘U’ bolts eliminates the door falling from the
brackets. (Do not tighten until Step 2.4, c.)
Centering Axle
(a)
(b)
Axle “Floats” in
either direction
BOTTOM RAIL AT 3 O’CLOCK
2.4 POSITION DOOR
a) Centre the door with the opening, while ensuring the
fl oating axle is also centred with the door.
Do this by lining up previous marks with the hub, then lift
both the axle and the door together until it is centred with
the opening.
b) Rotate the curtain and axle so that the bottom rail of the
door is positioned as shown (three o’clock).
c) Push the axle forward in the slots (toward the opening) and
tighten the nuts fi rmly without over-tightening. (10 Newton
metres or 6.6 feet/pounds torque reading).
NOTE:
Do not cut the plastic wrap or packaging yet.
6
Roll-A-Door
®
Series 1 Installation Instructions
