2.8 FITTING HANDLE
Fit the handle to the outside of the door using the screws, nuts and washers provided.
2.7 GUIDES
a) Check that curtain overlaps equally on both sides.
b) Check that guides are the correct length, that
is, level with the brackets (or in the restricted
headroom position are 35mm maximum above
bracket).
NOTE:
Restricted headroom is not
recommended when fi tting an opener.
c) Slide half the number of guide clips into each
guide.
d) Position the bottom clip 200mm from the fl oor
with the rest evenly spaced along the guide.
(Hint: to prevent clips from sliding down the
guide, temporarily secure them with adhesive
tape.) Now position one guide over the edge of
the door curtain.
e) Mark and drill the top fi xed guide clip and secure
using a 40mm x 8mm coach screw and washer,
allowing 3mm clearance between the inside of
the guide and plastic Roll-A-Guide.
f)
Ensuring guide is plumb, drill and fi x remaining
clips. (Note: if securing to uneven brickwork,
packers may be required behind clips, to prevent
them twisting out of square; also ensure that clips
are positioned on secure bricks).
g) With the top of the 2nd guide level with the fi rst,
repeat (e) and (f).
h) Remove the chock and slowly lower the door
removing plastic wrap as you pull door down,
reposition the guides as necessary to allow
smooth and even operation with 3mm clearance
throughout.
i)
Ensure door curtain enters guides smoothly. It
will be necessary to adjust the guide lead in to
achieve this.
RESTRICTED HEADROOM 35mm
SPACE
EVENLY
GUIDE
CLEARANCE
3mm
ROLL-A-GUIDE
200mm
DOOR
CURTAIN
(a)
(b)
(c)
(e)
(d)
NYLOFELT
GUIDE LEAD IN
(i)
8
Roll-A-Door
®
Series 1 Installation Instructions
