WEEKLY
Before start-up for the week:
Clean the inside surface of the thermostat probe. For this purpose, rotate the probe by 90 degrees
and remove any built up wax and lint from the probe by hand. Return the probe to its initial
position.
Remove the top panel (held in place with 2 each 5mm socket-head screws). Check the condi-
tion of the guide tape/braid between the pressing roller and the tape/braid guides. If a guide
tape/braid is missing, replace it immediately with a material of the same type (special high tem-
perature polyester).
WARNING: TO AVOID THE HAZARD OF ELECTRICAL SHOCK, DISCONNECT ELECTRI-
CAL SUPPLY.
QUARTERLY
Cleaning:
•
Check that the thermostat probe is clean by rotating it 90
◦
then put back into place and check
that it rests on the roller correctly.
33
