Introduction
3
EL6 Computer
The EL-6 Computer is a powerful and
programable solid state controller. Up to 30
programs, each with up to 15 cycles can be
programmed. In addition, the EL-6 can display
5 languages - English, Italian, German, Spanish
and French. The water level can be
programmed, and is accurate to 1 cm (0.4 in).
Spin speeds are fully programmable in RPM.
In the event of power failure, the operator is
prompted to continue the cycle, or abort it.
Keypad
7
8
9
DEL
RESET
Number key, Insert Key. Enables a new
cycle to be inserted in an existing program
during programming. During operation,
press and hold for cylinder RPM.
Number key, Decrement Key. Lowers the
current value during programming mode.
Number key, Increment Key. Raises the
current value during programming mode.
If pressed simultaneously with the TEMP or
LEVEL key, allows temporary
modification.
Number key, Temperature Key. Allows
temporary modification of the target
temperature if used with the INC and DEC
keys. Displays current temperature in wash
cylinder.
Number key, Level Key. Allows temporary
modification of the target water level if
used with the INC and DEC keys. Displays
current water level in wash cylinder.
Number key, Time Key. Displays the
watch dog timer value for the current step.
Number keys
Number key, Pause Key. If pressed during
operation, pauses the wash program
indefinitely. Not active during distribution
or spin.
Advances to the next program step.
During final spin, the remainder of the spin
is aborted. If pressed before starting a
program, it allows the operator to begin the
program at any segment. During
programing, skips to the next segment.
Confirms settings in creation and editing of
wash programs. During operation, shows
the current segment or program number.
Deletes any selection or setting.
Terminates the current activity (operation
or programming). While the machine is
powered but not executing a program, can
be pressed with RESET to see the current
firmware version.
Starts execution of the currently selected
wash program. Restarts a paused
program. When pressed with RESET,
function codes can be entered to program
and setup the machine. See the quick
reference list on the next page.
1
3
2
4
5
6
0
ENTER
PAUSE
INS
TEMP
DEC
LEVEL
INC
TIME
ADVAN
