Service Functions
26
Access Functions continued
Maximum Spin Speed
Function 201
This function allows you to display or modify
the maximum spin speed. Upon entering the
function, the display will show the current
value. To exit without changing, press RESET.
If you wish to change the value, press ENTER,
type the new value, and press ENTER again. If
the value is within the acceptable range, the
display will show YES. Otherwise, the display
will show NO. Do not modify unless instructed
by B&C Technologies!
Temperature Hysterisis
Function 209
This function sets the allowed temperature
variation parameter. The default value is 3
degrees. If you wish to change the value, press
ENTER, key in the new value (1 - 10 degrees
C), then press ENTER again to confirm. To exit
without changing, press RESET.
Temperature Display
Function 210
Function 211
During program execution, the temperature
may be displayed in degrees Fahrenheit or
degrees Centigrade. For degrees F, enter
function 211. For degrees C, enter function
210. Please note that this is for display only.
Programming is always done in degrees C. See
the handy conversion chart in the back of this
manual.
Maximum Water Level
Function 212
This function allows display and modification of
the maximum programmable water level. To
change the value, press ENTER, type in the
new value, and press ENTER again to confirm.
To exit without modification, press RESET. The
allowable values are 11 to 100 cm. Do not
modify unless instructed by B&C Technologies!
Minimum Level for Heat
Function 213
This function sets the minimum allowable water
level for heat to activate. Upon entering the
function, the value will be displayed. To
modify, press ENTER. Type the new value, and
press ENTER again to confirm.
DO NOT MODIFY
WITHOUT CONSULTING
B&C TECHNOLOGIES OR A
QUALIFIED SERVICE
TECHNICIAN! EXTREME
MACHINE DAMAGE CAN
OCCUR!
Hours of Work
Function 214
Entering function 214 displays the total number
of hours the machine has operated. The
display shows the value for about 3 seconds.
Only complete cycles are counted for this timer
- partially complete cycles are not counted as
part of the total work time.
Total Number of Washes
Function 215
This function shows the total number of wash
programs executed since the machine was
installed.
Number of Washes since last Maintenance
Function 216
This function shows the total number of wash
programs executed since the last required
maintenance was performed (set with function
218).
Reset Maintenance Alarm
Function 217
This function resets the maintenance alarm, but
does not clear the number of washes counter
(function 215). Before resetting the alarm,
PERFORM ROUTINE MAINTENANCE AS
OUTLINED IN THE OPERATION MANUAL.
PERFORM ROUTINE MAINTENANCE AS
OUTLINED IN THE OPERATION MANUAL.
