Maintenance Required
Function 218
This function sets the number of washes before
the maintenance alarm is activated. The
default value is 450. This means that after 450
wash programs have been completed, the
maintenance alarm will be displayed. To
change the value, use the INC or DEC keys.
The value changes by 10 each time a key is
pressed. You may hold down the key to
change the number quickly. Once the desired
value is reached, press the ENTER key to
confirm.
Spin Safety Coast Down Time
Function 219
Upon entering function 219, you display the
spin safety coast down time. If you wish to
change this (
not
recommended), press ENTER,
followed by the new value, then ENTER to
confirm. To exit without changing the value,
press RESET.
DO NOT MODIFY
WITHOUT CONSULTING
B
&
C TECHNOLOGIES!
EXTREME MACHINE
DAMAGE
AND PERSONAL
INJURY
CAN OCCUR!
Memory Erasure
Function 181
Function 220
Partial or total clearing of the control memory is
possible. Function 220 clears all programs and
cycles, but machine parameters are not erased.
Function 181 erases all programs and cycles,
and also erases all machine parameters, thus
reinitializing the control. After keying in the
function, the display reads: “DELETE
E2PROM?” Press ENTER to confirm. Press
RESET to abort the procedure.
Service Functions
27
Access Functions continued
Memory Card
The control allows transfer of programs from
and to a credit card sized memory card. This
allows great flexibility in programming. The
card must be inserted into the control with the
contacts facing up. Card insertion and removal
must be done with the machine powered down.
Function 221
To transfer programs, cycles and parameters
onto the memory card, use function 221.
1. Power down the machine
2. Insert the memory card
3. START + RESET
4. 221
5. ENTER
The display now shows “COPY TO CARD?”
6. Press ENTER
The display now shows “COPY TO CARD”
followed by “COPY OK.”
Function 222
Function 222 works exactly like function 221,
except it transfers programs and cycles from the
memory card to the control.
1. Power down the machine
2. Insert the memory card
3. START + RESET
4. 222
5. ENTER
The display now shows “COPY FROM
CARD?”
6. Press ENTER
The display now shows “COPY FROM CARD”
followed by “COPY OK.”
Function 223
Function 223 works exactly like function 222,
except it transfers programs, cycles
and
machine parameters
from the memory card to
the control.
1. Power down the machine
2. Insert the memory card
3. START + RESET
4. 223
