3
The binding process effectively ties the transmitter and receiver together. Under normal circumstances,
both items are supplied like this from the factory. If, however, you find that your transmitter and receiver
are not bound(receiver’s red LED is on), you should do the following:
1) Switch “ON” the transmitter.
2) Switch “ON” the receiver by Attaching the 7.4V power pack’s connector to the matching connector in
the Mad Shark boat.
3) Press down the “BIND” button on the receiver, the receiver’s green LED will be on to indicate that
binding has been successful and the receiver will now accept commands from the transmitter.
During binding process, transmitter and receiver should be no more than one meter apart and
no other similar devices should be within 10 meters.
if the green light flashing, showing the binding failure, please do again as above indication.
TRANSMITTER/RECEIVER BINDING
Mad Shark V2 RTR MiNi EP F1 Speed Boat
NOTE:
1. There is a water proof rubber ring
placed inside the slot of hull, always
make sure it’s secured positioned
before re-position the hatch.
3. Place the boat hull on the polyfoam boat stand
4. Fixt the charged finished battery inside the hull
with velco strap.
5. Attach battery connector to the matching
connector of ESC.
6. Re-position hatch by rotating plastic locks at the
hatch firstly, then rotate the plastic lock
underneath the boat head.
INSTALLING THE 7.4V POWER PACK IN THE MAD SHARK
1. Switch on transmitter power, the light glows bright red.
2. firstly rotate the plastic lock underneath the boat head, then rotate the four plastic lock at the hatch as photo show
to remove the hatch.
NOTE 1:
NOTE 1:
6
3
4
5
NOTE 1:
The Mad Shark brushed F1 will typically run for around 8 minutes on a fully charged 7.4V Power Pack. As
soon as you notice a drop off in speed you should bring the model back to shore or control may be lost.
3) Never leave the battery unattended during the charging process. Always keep this charger out of reach of children.
4) Do not attempt to disassemble the charger
5) Un-plug the charger from the power outlet if you do not intend to use it for a period of time.
