5
Please observe the following warnings.
• The transmitter’s range will vary depending on your surroundings and battery strength.Do not operate
Mad Shark too far away or control will be lost.
• Ensure that all batteries are correctly installed and that the 7.4V Power Pack is fully charged.
• Do not operate your Mad Shark in areas with strong currents, in salt water or areas of water with large
waves.
• Do not touch moving parts during operation, especially the propeller.
• Do not let your Mad Shark run aground, as this can cause damage.
• If you lose control of your Mad Shark, never wade into deep water or water with strong currents to
retrieve it. First, hold the transmitter as high as you can to try to re-establish control. If this does not work,
find another way to move closer to the model, but do not endanger yourself in the process!
GENERAL INFORMATION FOR THE SAFE OPERATION OF YOUR MAD SHARK
Please follow these simple rules to ensure safe operation and gain the maximum enjoyment from
your model.
•
Avoid overloading your model. Never run it in areas where its movement will be restricted, e.g. areas
where there is pond weed, etc., as this can over stress the motor.
•
Ensure nothing prevents the smooth running of moving parts.
•
Do not run your model in confined spaces.
•
Never run your model in a public space where it might upset or endanger people or wildlife.
•
Immediately switch ‘OFF’ your model and transmitter if you see lightning or hear thunder.
Never use your model in the rain.
Do not dismantle or tamper in any way with this R/C vehicle and its transmitter. The manufacturer and
distributor will accept no responsibility, expressed or implied, for accidents or injuries caused as a result of
disassembly,modification and/or usage against the Instructions for this product.
Tampering or modification will also invalidate the guarantee.
Lubricating the flexshaft is vital to the life of the drivetrain. The
lubricant also acts as a water seal, keeping water from entering
the hull through the stuffing tube. Lubricating the flexshaft,
propeller shaft after every 2 or 3 times of operation.
1. Use the 2mm Allen key to loose the two grub screws of the
coupler which connects the flexshaft, then slide the flexshaft
w/ prop shaft out of the stuffing tube.
2. Lubricate the flexshaft w/ prop shaft with the water proof
marine grease, reinstall the flexshaft w/ prop shaft in reverse
order, be sure to retighten the two grub screws of coupler.
Mad Shark V2 RTR MiNi EP F1 Speed Boat
CAUTION!
MAINTAINING THE DRIVESHAFT
DURING OPERATION
