35 / 78
0006081053 - ed 2006/12
APPLICATION OF BURNER TO BOILER
HEAD UNIT ASSEMNLY
A) Adjust the position of
connector fl ange 5 by loose
ning the screws 6 so that
the combustion head pene
trates the advised amount into
the combustion
chamber as recommended by
the generator’s manufacturer.
B) Position the seal insulation 3
on the tube unit inserting cord
2 between fl ange and seal.
C) Fasten the Combustion Head
unit 4 to the boiler 1 by means
of the stud bolts, washers and
the nuts provided 7.
ASSEMBLYOFVENTILATION
SYSTEM
A) Position the half-hinge on the
burner scroll in line with those
on the combustion head as
sembly.
B) Put the hinge pin 10 in the
position considered most
suitable.
C) Connect the cable switch on
to thecorresponding electro-
des, close the hinge, locking
the burner by means of
screws 11.
COMPLETING BURNER SETUP
1) Remove the protective yellow
caps from the connectors be
neath the combustion head
and close to the solenoid
valves.
2) Connect the 12 light oil pipes
provided with the burner to
their corresponding
connectors, making sure they
are properly sealed.
