baltur TBG 320SLX ME, Instruction Manual For Installation, Use And Maintenance

Page: 58 / 100

DESIGN CHARACTERISTICS
The burner consists of:
• Ventilating part in light aluminium alloy.
• Centrifugal fan for high performances.
• Intake air conveyor.
• Adjustable combustion head complete with stainless steel nozzle.
• Flame inspection glass.
• Three-phase electric motor to run fan.
• Air pressure switch to ensure the presence of combustion air.
• Main gas train in EC version consisting of an operating and safety
valve with electro-magnetic operation, valve seal control, minimum
and maximum pressure switch, pressure regulator and gas filter.
• Flame detection by means of ionisation electrode.
• Automatic burner command and control equipment with
microprocessor in compliance with European standard EN298
integrated with valve seal control.
• Electrical system with protection rating IP54.
TECHNICAL FUNCTIONAL CHARACTERISTICS
• Gas burner compliant with the European standards EN 676 and with
the European Directives 2006/42/CE; 2014/30/UE; 2014/35/UE;
(UE) 2016/426.
• Operation with two progressive power stages.
• Adjustable combustion head for optimising combustion.
• Hinge opens both ways to permit convenient access to the mixer
without dismantling the burner from the boiler.
• Fuel / combustion air flow rate regulation by means of three servo
motors controlled by the electronic equipment.
• Damper closing in pause to prevent any heat dispersion to the flue.
OPERATING RANGE
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
mbar / hPa
0 1000 2000 3000 4000 5000 6000 kW
CDL_
TB
G_
32
0S
LX
_M
E
TBG 320SLX ME
TBG 480SLX ME
IMPORTANT
The operating ranges are obtained from test boilers corresponding to Standard EN676 and are indicative of the burner-boiler combination.
For correct working of the burner, the size of the combustion chamber must correspond to current regulations; if not the manufacturers
must be consulted.
The burner shall not operate outside its specific operating range.
DANGER / ATTENTION
During the ignition and adjustment phase, check that the maximum and minimum outputs at which the burner is adjusted are within the
working range in order to avoid damage to the system.
8 / 48
0006160489_202211
ENGLISH